Jeep Wrangler: STEERING WHEEL / Heated Steering Wheel — If Equipped
The steering wheel contains a heating element
that helps warm your hands in cold weather.
The heated steering wheel has only one
temperature setting. Once the heated steering
wheel has been turned on, it will stay on until
the operator turns it off. The heated steering
wheel may not turn on when it is already warm.
The heated steering wheel control button is
located within the climate or controls screen of
the touchscreen.
- Push the heated steering wheel button
once to turn the heating
element on.
- Push the heated steering wheel button
a
second time to turn the heating element off.
NOTE:
The engine must be running for the heated
steering wheel to operate.
For information on use with the Remote Start
system.
WARNING!
- Persons who are unable to feel pain to the
skin because of advanced age, chronic
illness, diabetes, spinal cord injury, medication,
alcohol use, exhaustion, or other physical
conditions must exercise care when
using the steering wheel heater. It may
cause burns even at low temperatures,
especially if used for long periods.
- Do not place anything on the steering wheel
that insulates against heat, such as a
blanket or steering wheel covers of any type
and material. This may cause the steering
wheel heater to overheat.
This feature allows you to tilt the steering
column upward or downward. It also allows you
to lengthen or shorten the steering column. The
tilt/telescoping lever is located on the steering
column...
Seats are a part of the Occupant Restraint
system of the vehicle.
WARNING!
It is dangerous to ride in a cargo area,
inside or outside of a vehicle...
Other information:
This warning light monitors
various
brake functions, including brake fluid
level and parking brake application. If
the brake light turns on it may
indicate that the parking brake is applied, that
the brake fluid level is low, or that there is a
problem with the Anti-Lock Brake System
reservoir...
The end caps on your vehicle’s front fascia/
bumper can be removed by following the steps
below:
NOTE:
Bumper end caps are removable on steel
fascia/bumper only.
Loosen the two bolts that retain the GAWR
bracket (Bolts #1 and #2) to the end cap
using a T45 torx bit screw driver...