Jeep Wrangler: Manual Climate Control Descriptions And Functions / A/C Button
Push the A/C button to engage
the Air
Conditioning (A/C). The A/C indicator
illuminates when A/C is on.
NOTE:
- For Manual Climate Controls, if the system is
in Mix, Floor or Defrost Mode, the A/C can be
turned off, but the A/C system shall remain
active to prevent fogging of the windows.
- If fog or mist appears on the windshield or
side glass, select Defrost mode, and increase
blower speed if needed.
- If your air conditioning performance seems
lower than expected, check the front of the
A/C condenser (located in front of the radiator),
for an accumulation of dirt or insects.
Clean with a gentle water spray from the front
of the radiator and through the condenser.
Set the temperature control knob
to
the MAX A/C setting to change the
current setting to the coldest output
of air. Moving the temperature control
knob away from the MAX A/C setting causes the
MAX A/C operation to exit...
Push the recirculation button on
the
faceplate to change the system
between recirculation mode and
outside air mode. The Recirculation
indicator and the A/C indicator (if equipped)
illuminate when the Recirculation button is pressed...
Other information:
The minimum set speed for the ACC system is
20 mph (32 km/h).
When the system is turned on and in the ready
state, the instrument cluster displays “ACC
Ready.”
When the system is off, the instrument cluster
displays “Adaptive Cruise Control (ACC) Off...
WARNING!
Vehicles with the Stop/Start system will be
equipped with two batteries. Both the main
and the supplemental batteries must be
disconnected to completely de-energize the
12 Volt electrical system.
Serious injury or death could result if you do
not disconnect both batteries...