Jeep Wrangler 2018-2025 Owners Manual / MULTIMEDIA / CONNECTED SERVICES FAQs / Connected Services Vehicle Finder FAQs

Jeep Wrangler: CONNECTED SERVICES FAQs / Connected Services Vehicle Finder FAQs

  1. Can someone else locate my vehicle? Your vehicle may be located by anyone who has your PIN and access to your account. It is your responsibility to guard your PIN accordingly. See the Uconnect and SiriusXM Guardian™ terms of service for more information.
  2. How long does it take to sound my horn and flash the lights? Depending on various conditions, it can take three minutes or more for the request to get through to your vehicle.
  3. How do I turn off the horn and lights after I turn them on? If you are close enough to the vehicle, you can use the key fob to turn off the horn and lights by pressing the red Panic button.

    Connected Services Send & Go FAQs

    How long does it take to send the route and destination to my vehicle? Depending on various conditions, it can take up to three minutes for the request to get through to your vehicle...

    Connected Services Stolen Vehicle Assistance FAQs

    Can someone locate my vehicle? To enhance your privacy, and the privacy of others using your vehicle, a stolen vehicle police report is required for you to activate this service...

    Other information:

    Jeep Wrangler 2018-2025 Owners Manual: Removing The Rear Seat


    Push down on the release bar on each side, and pull the seat out and away from the lower bracket. Release Bar Location Remove the seat from the vehicle. To reinstall the rear seat, just reverse these steps. NOTE: Do not drive the vehicle without reattaching the rear seat latches...

    Jeep Wrangler 2018-2025 Owners Manual: AdBlue® (UREA) Injection System Failure Warning Light — If Equipped


    This warning light will illuminate along with a dedicated message on the display (if equipped) if an unknown fluid not conforming with acceptable characteristics is inserted, or if an average consumption of AdBlue® (UREA) over 50% is detected...

    Categories

    Manual Front Seat Forward/Rearward Adjustment

    The seat can be adjusted forward or rearward by using a bar located by the front of the seat cushion, near the floor. While sitting in the seat, lift up on the bar located under the seat cushion and move the seat forward or rearward. Release the bar once you have reached the desired position. Then, using body pressure, move forward and rearward on the seat to be sure that the seat adjusters have latched.

    Jeep Wrangler. Manual Front Seat Forward/Rearward Adjustment

    Adjustment Bar Location

    read more

     
    Copyright © 2025 www.jewrangler.com