Jeep Wrangler: Automatic Transmission — If Equipped / Fluid And Filter Changes
Under normal operating conditions, the fluid
installed at the factory will provide satisfactory
lubrication for the life of the vehicle.
Routine fluid and filter changes are not
required. However, change the fluid and filter if
the fluid becomes contaminated (with water,
etc.), or if the transmission is disassembled for
any reason.
The fluid level is preset at the factory and does
not require adjustment under normal operating
conditions. Routine fluid level checks are not
required; therefore the transmission has no
dipstick...
It is important to use the proper transmission
fluid to ensure optimum transmission
performance and life. Use only the
manufacturer specified transmission fluid...
Other information:
Proper lug nut/bolt torque is very important to
ensure that the wheel is properly mounted to
the vehicle. Any time a wheel has been removed
and reinstalled on the vehicle, the lug nuts/
bolts should be torqued using a properly
calibrated torque wrench using a six sided (hex)
deep wall socket...
The jack and lug wrench are located in the rear
cargo area. To remove jack and tools proceed
as follows:
Lift the load floor in the cargo area.
Load Floor
NOTE:
The load floor can be removed for easier access
by pulling the load floor directly rearward...