Jeep Wrangler: Fold And Tumble Rear Seat — Two Door Models / Folding The Rear Seat

  1. Lift the seatback release lever and fold the seatback forward.

    Jeep Wrangler. Folding The Rear Seat

    Rear Seatback Release Lever

  2. Slowly flip the entire seat forward.

    Fold And Tumble Rear Seat — Two Door Models

    NOTE: Prior to folding the rear seat, it may be necessary to reposition the front seats. Be sure that the front seats are fully upright and positioned forward...

    Using The Retention Straps

    There are two retention straps located on the back of the rear seat and two corresponding wire loops located on the back of each B-pillar. Open the hook-and-loop fastener on the strap and thread through the wire loop...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Manual Transmission — If Equipped


    Apply the parking brake, place the gear selector in NEUTRAL, and press the clutch pedal before starting the vehicle. This vehicle is equipped with a clutch interlocking ignition system. It will not start unless the clutch pedal is pressed to the floor...

    Jeep Wrangler 2018-2026 Owners Manual: Fuel Filter Replacement — Diesel Engine


    NOTE: Using a fuel filter that does not meet the manufacturer’s filtration and water separating requirements can severely impact fuel system life and reliability. We recommend you use Mopar® Fuel Filter. Must meet 3 micron rating. CAUTION! Diesel fuel will damage blacktop paving surfaces...

    Categories

    Turn Signals. Lane Change Assist — If Equipped

    Turn Signals

    Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.

    NOTE:

    If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.

    read more

     
    Copyright © 2026 www.jewrangler.com