Jeep Wrangler: IN CASE OF EMERGENCY / IF YOUR ENGINE OVERHEATS

If the vehicle is overheating, it will need to be serviced by an authorized dealer.

In any of the following situations, you can reduce the potential for overheating by taking the appropriate action.

  • On the highways — slow down.
  • In city traffic — while stopped, shift transmission into NEUTRAL, but do not increase engine idle speed.

CAUTION!

Driving with a hot cooling system could damage your vehicle. If the temperature gauge reads HOT (H), pull over and stop the vehicle. Idle the vehicle with the air conditioner turned off until the pointer drops back into the normal range. If the pointer remains on HOT (H), and you hear continuous chimes, turn the engine off immediately and call for service.

NOTE:

There are steps that you can take to slow down an impending overheat condition:

  • If your Air Conditioner (A/C) is on, turn it off. The A/C system adds heat to the engine cooling system and turning the A/C off can help remove this heat.
  • You can also turn the temperature control to maximum heat, the mode control to floor and the blower control to high. This allows the heater core to act as a supplement to the radiator and aids in removing heat from the engine cooling system.

WARNING!

You or others can be badly burned by hot engine coolant (antifreeze) or steam from your radiator. If you see or hear steam coming from under the hood, do not open the hood until the radiator has had time to cool. Never try to open a cooling system pressure cap when the radiator or coolant bottle is hot.

    Disconnecting The Jumper Cables

    Disconnect the negative (-) end of the jumper cable from the engine ground of the vehicle with the discharged battery. Disconnect the opposite end of the negative (-) jumper cable from the negative (-) post of the booster battery...

    MANUAL PARK RELEASE

    WARNING! Always secure your vehicle by fully applying the parking brake before activating the Manual Park Release. In addition, you should be seated in the driver’s seat with your foot firmly on the brake pedal when activating the Manual Park Release...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: MANUAL TRANSMISSION — IF EQUIPPED


    WARNING! You or others could be injured if you leave the vehicle unattended without having the parking brake fully applied. The parking brake should always be applied when the driver is not in the vehicle, especially on an incline. CAUTION! Never drive with your foot resting on the clutch pedal, or attempt to hold the vehicle on a hill with the clutch pedal partially engaged, as this will cause abnormal wear on the clutch...

    Jeep Wrangler 2018-2026 Owners Manual: Programming And Requesting Additional Key Fobs


    Programming the key fob may be performed by an authorized dealer.NOTE: Once a key fob is programmed to a vehicle, it cannot be repurposed and reprogrammed to another vehicle. Only key fobs that are programmed to the vehicle electronics can be used to start and operate the vehicle...

    Categories

    Manual Seat Height Adjustment

    The driver's seat height can be raised or lowered by using the ratcheting handle, located on the outboard side of the seat. Pull upward on the handle to raise the seat, push downward on the handle to lower the seat. Several strokes may be necessary to achieve the desired position.

    Jeep Wrangler. Manual Seat Height Adjustment

    Seat Height Adjustment

    read more

     
    Copyright © 2026 www.jewrangler.com