Jeep Wrangler 2018-2026 Owners Manual / IN CASE OF EMERGENCY / JUMP STARTING / Jump Starting Procedure

Jeep Wrangler: JUMP STARTING / Jump Starting Procedure

WARNING!

Failure to follow this jump starting procedure could result in personal injury or property damage due to battery explosion.

CAUTION!

Failure to follow these procedures could result in damage to the charging system of the booster vehicle or the discharged vehicle.

NOTE:

Make sure at all times that unused ends of jumper cables are not contacting each other or either vehicle while making connections.

Preparations For Jump Start

Supplemental Battery — If Equipped WARNING! Only use the positive battery post on the main battery to jump start your vehicle. Serious injury or death could result if you attempt to jump start using the supplemental battery...

Connecting The Jumper Cables

Connect the positive (+) end of the jumper cable to the remote positive (+) post of the discharged vehicle. Connect the opposite end of the positive (+) jumper cable to the positive (+) post of the booster battery...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Transporting Passengers and Pets

Transporting Passengers NEVER TRANSPORT PASSENGERS IN THE CARGO AREA. WARNING! Do not leave children or animals inside parked vehicles in hot weather. Interior heat build-up may cause serious injury or death. It is extremely dangerous to ride in a cargo area, inside or outside of a vehicle...

Jeep Wrangler 2018-2026 Owners Manual: Auxiliary Switches — If Equipped

Four auxiliary switches located in the lower switch bank of the instrument panel can be used to power various electrical devices. You have the ability to configure the functionality of the auxiliary switches via the Uconnect Settings. All switches can be configured as follows: Switch type operation: Latching or Momentary Power source: Battery or Ignition Ability to hold last state across key cycles: On or Off Auxiliary Switches NOTE: Holding last state conditions are met when switch type is set to latching and power source is set to ignition...

Bi-Level Mode

Jeep Wrangler. Bi-Level Mode Air comes from the instrument panel outlets and floor outlets. A slight amount of air is directed through the defrost and side window demister outlets.