Jeep Wrangler: STARTING AND OPERATING / MANUAL TRANSMISSION — IF EQUIPPED
WARNING!
You or others could be injured if you leave the
vehicle unattended without having the
parking brake fully applied. The parking brake
should always be applied when the driver is
not in the vehicle, especially on an incline.
CAUTION!
- Never drive with your foot resting on the
clutch pedal, or attempt to hold the vehicle
on a hill with the clutch pedal partially
engaged, as this will cause abnormal wear
on the clutch.
- Do not drive with your hand resting on the
gear selector as the force exerted, even if
slight, could lead over time to premature
wear of the gearbox internal components.
NOTE:
During cold weather, you may experience
increased effort in shifting until the transmission
fluid warms up. This is normal.

Transmission Gear Selector
To shift the gears, fully press the clutch pedal
and place the gear selector into the desired
gear position (the diagram for the engagement
of the gears is displayed on the handle of the
selector).
To engage REVERSE gear from the NEUTRAL
position, lift the REVERSE ring, located below
the knob and move the gear selector all the way
left and then forward.

Shift Pattern
Before exiting the vehicle, make sure that the
parking brake is fully applied. Also, be certain to
leave an automatic transmission in PARK, or
manual transmission in REVERSE or FIRST
gear...
Fully press the clutch pedal before shifting
gears. As you release the clutch pedal, lightly
press the accelerator pedal.
You should always use FIRST gear when starting
from a standing position...
Other information:
Press and release the Rear
Defrost
button on the touchscreen, or push
and release the button on the
faceplate, to turn on the rear window
defroster and the heated outside mirrors (if
equipped). The Rear Defrost indicator
illuminates when the rear window defroster is
on...
The rear axle may be locked in 4WD High if the
proper conditions are met.
WARNING!
This mode is intended for off-highway or
off-road use only and should not be used on
any public roadways.
The AXLE LOCK switch is located on the
instrument panel (to the right of the steering
column)...