Jeep Wrangler: HOOD / Opening The Hood
If applicable, refer to the “Hybrid Supplement”
for additional information.
Release both the hood latches.

Hood Latch Locations
Raise the hood and locate the safety latch,
located in the middle of the hood opening. Push
the safety latch to the right to open the hood.
You may have to push down slightly on the hood
before pushing the safety latch. Unhook the
support rod from the hood and insert it into the
slot on the front end above the radiator.
If applicable, refer to the “Hybrid Supplement”
for additional information.
To close the hood, remove the support rod from
the slot and replace it on the hood panel
retaining clip...
Other information:
If a seat belt is not long enough to fit properly,
even when the webbing is fully extended and
the adjustable upper shoulder belt anchorage
(if equipped) is in its lowest position, an
authorized dealer can provide you with a Seat
Belt Extender. The Seat Belt Extender should be
used only if the existing seat belt is not long
enough...
TO MANUALLY TURN OFF THE STOP/START SYSTEM
Stop/Start OFF Switch
Push the Stop/Start OFF switch (located on the
switch bank). The light on the switch will
illuminate. The “Stop/Start OFF” message will
appear in instrument cluster display within the
Stop/Start section, and the autostop function
will be disabled...