Jeep Wrangler: Red Warning Lights / Swing Gate Open Warning Light
This warning light will
illuminate when
the swing gate is open.
NOTE:
If the vehicle is moving, there will also be a
single chime.
This warning light will
illuminate to
indicate the engine oil temperature is
high. If the light turns on while driving,
stop the vehicle and shut off the
engine as soon as possible...
This warning light will
illuminate to
warn of a high transmission fluid
temperature. This may occur with
strenuous usage such as trailer
towing. If this light turns on, stop the vehicle and run the engine at idle or
slightly faster, with the
transmission in PARK (P) or NEUTRAL (N), until
the light turns off...
Other information:
All wheels and wheel trim, especially aluminum
and chrome plated wheels, should be cleaned
regularly using mild (neutral Ph) soap and water
to maintain their luster and to prevent
corrosion. Wash wheels with the same soap
solution recommended for the body of the
vehicle and remember to always wash when the
surfaces are not hot to the touch...
Four auxiliary switches located in the lower
switch bank of the instrument panel can be
used to power various electrical devices. You
have the ability to configure the functionality of
the auxiliary switches via the Uconnect Settings.
All switches can be configured as follows:
Switch type operation: Latching or Momentary
Power source: Battery or Ignition
Ability to hold last state across key cycles: On or Off
Auxiliary Switches
NOTE:
Holding last state conditions are met when
switch type is set to latching and power source
is set to ignition...