Jeep Wrangler: STOP/START SYSTEM — MANUAL TRANSMISSION (IF EQUIPPED) / To Manually Turn On The Stop/Start System
Push the Stop/Start OFF switch (located on the
switch bank). The light on the switch will turn
off.
Push the Stop/Start OFF switch (located on
the switch bank). The light on the switch
will illuminate.
Stop/Start OFF Switch
The STOP/START OFF message will appear
in the instrument cluster...
If there is a malfunction in the Stop/Start
system, the system will not shut down the
engine. A “SERVICE STOP/START SYSTEM”
message will appear in the instrument cluster
display...
Other information:
FCA strongly recommends against using any
special additives in the transmission. Automatic
Transmission Fluid (ATF) is an engineered
product and its performance may be impaired
by supplemental additives. Therefore, do not
add any fluid additives to the transmission...
Push down on the release bar on each
side, and pull the seat out and away from
the lower bracket.
Release Bar Location
Remove the seat from the vehicle.
To reinstall the rear seat, just reverse these
steps.
NOTE:
Do not drive the vehicle without reattaching the
rear seat latches...