Jeep Wrangler: STARTING AND OPERATING / TRAILER TOWING
In this section you will find safety tips and information on limits to the type of towing you can reasonably do with your vehicle. Before towing a trailer, carefully review this information to tow your load as efficiently and safely as possible.
To maintain the New Vehicle Limited Warranty coverage, follow the requirements and recommendations in this manual concerning vehicles used for trailer towing.
- Common Towing Definitions
- Trailer Hitch Classification
- Trailer Towing Weights (Maximum Trailer Weight Ratings)
- Trailer And Tongue Weight
- Towing Requirements
- Towing Tips
VEHICLE LOADING
CERTIFICATION LABEL
As required by National Highway Traffic Safety
Administration regulations, your vehicle has a
certification label affixed to the driver's side
door or pillar...
Common Towing Definitions
The following trailer towing related definitions
will assist you in understanding the following
information:
The GVWR is the total allowable weight of your
vehicle...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: IGNITION SWITCH
KEYLESS ENTER-N-GO IGNITION If applicable, refer to the “Hybrid Supplement” for additional information. This feature allows the driver to operate the ignition switch with the push of a button as long as the key fob is in the passenger compartment...
Jeep Wrangler 2018-2026 Owners Manual: Exhaust Gas
WARNING! Exhaust gases can injure or kill. They contain carbon monoxide (CO), which is colorless and odorless. Breathing it can make you unconscious and can eventually poison you. To avoid breathing (CO), follow these safety tips: Do not run the engine in a closed garage or in confined areas any longer than needed to move your vehicle in or out of the area...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Turning FCW On Or Off
- Jack Location
- 2.0L Engine and 3.6L Engine
- New on site
- Most important about car
Manual Front Seat Forward/Rearward Adjustment
The seat can be adjusted forward or rearward by using a bar located by the front of the seat cushion, near the floor. While sitting in the seat, lift up on the bar located under the seat cushion and move the seat forward or rearward. Release the bar once you have reached the desired position. Then, using body pressure, move forward and rearward on the seat to be sure that the seat adjusters have latched.
Adjustment Bar Location
