Jeep Wrangler: Yellow Indicator Lights / 4WD Part Time Indicator Light — If Equipped
This light alerts the driver
that the
vehicle is in the four-wheel drive part
time mode, and the front and rear
driveshafts are mechanically locked
together forcing the front and rear wheels to
rotate at the same speed.
This light alerts the driver
that the
vehicle is in the four-wheel drive LOW
mode. The front and rear driveshafts
are mechanically locked together
forcing the front and rear wheels to rotate at the
same speed...
Other information:
There are two retention straps located on
the back of the rear seat and two
corresponding wire loops located on the
back of each B-pillar. Open the
hook-and-loop fastener on the strap and
thread through the wire loop. Fold the
hook-and-loop fastener over to keep the
seat in the folded position...
This indicator shows when the
HDC
feature is turned on. The lamp will be
on solid when HDC is armed. HDC can
only be armed when the transfer case
is in the “4WD Low” position and the vehicle
speed is less then 30 mph (48 km/h). If these
conditions are not met while attempting to use
the HDC feature, the HDC indicator light will
flash on/off...