Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR INSTRUMENT PANEL / WARNING LIGHTS AND MESSAGES / Yellow Indicator Lights / 4WD Low Indicator Light — If Equipped
Jeep Wrangler: Yellow Indicator Lights / 4WD Low Indicator Light — If Equipped
This light alerts the driver
that the
vehicle is in the four-wheel drive LOW
mode. The front and rear driveshafts
are mechanically locked together
forcing the front and rear wheels to rotate at the
same speed. Low range provides a greater gear
reduction ratio to provide increased torque at
the wheels.
4WD Indicator Light — If Equipped
This light alerts the driver
that the
vehicle is in the four-wheel drive
mode, and the front and rear
driveshafts are mechanically locked
together forcing the front and rear wheels to
rotate at the same speed...
4WD Part Time Indicator Light — If Equipped
This light alerts the driver
that the
vehicle is in the four-wheel drive part
time mode, and the front and rear
driveshafts are mechanically locked
together forcing the front and rear wheels to
rotate at the same speed...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Hill Climbing
Hill climbing requires good judgment and a good understanding of your abilities and your vehicle's limitations. Hills can cause serious problems. Some are just too steep to climb and should not be attempted. You should always feel confident with the vehicle and your abilities...
Jeep Wrangler 2018-2026 Owners Manual: Programming And Requesting Additional Key Fobs
Programming the key fob may be performed by an authorized dealer.NOTE: Once a key fob is programmed to a vehicle, it cannot be repurposed and reprogrammed to another vehicle. Only key fobs that are programmed to the vehicle electronics can be used to start and operate the vehicle...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Turning FCW On Or Off
- Automatic High Beam Headlamp Control — If Equipped, Flash-To-Pass
- WHEEL AND TIRE TORQUE SPECIFICATIONS
- New on site
- Most important about car
Manual Seat Height Adjustment
The driver's seat height can be raised or lowered by using the ratcheting handle, located on the outboard side of the seat. Pull upward on the handle to raise the seat, push downward on the handle to lower the seat. Several strokes may be necessary to achieve the desired position.
Seat Height Adjustment
Copyright © 2026 www.jewrangler.com