Jeep Wrangler 2018-2026 Owners Manual / GETTING TO KNOW YOUR VEHICLE / CLIMATE CONTROLS / Automatic Temperature Control (ATC) — If Equipped

Jeep Wrangler: CLIMATE CONTROLS / Automatic Temperature Control (ATC) — If Equipped

Automatic Operation

  1. Push the AUTO button on the faceplate, or the AUTO button on the touchscreen on the Automatic Temperature Control (ATC) Panel.
  2. Next, adjust the temperature that you would like the system to maintain by adjusting the driver and passenger temperature control buttons. Once the desired temperature is displayed, the system will achieve and automatically maintain that comfort level.
  3. When the system is set up for your comfort level, it is not necessary to change the settings. You will experience the greatest efficiency by simply allowing the system to function automatically.

NOTE:

  • It is not necessary to move the temperature settings for cold or hot vehicles. The system automatically adjusts the temperature, mode, and blower speed to provide comfort as quickly as possible.
  • The temperature can be displayed in US or Metric units by selecting the US/Metric customer-programmable feature within Uconnect Settings.

To provide you with maximum comfort in the Automatic mode during cold start-ups, the blower fan will remain on low until the engine warms up. The blower will increase in speed and transition into Auto mode.

Manual Operation Override

This system offers a full complement of manual override features. The AUTO symbol in the front ATC display will be turned off when the system is being used in the manual mode.

    Climate Control OFF

    ..

    Climate Voice Commands

    Adjust vehicle temperatures hands-free and keep everyone comfortable while you keep moving ahead. Push the VR button on the steering wheel. After the beep, say one of the following commands: “Set the driver temperature to 70 degrees” “Set the passenger temperature to 70 degrees” Did You Know: Voice Command for Climate may only be used to adjust the interior temperature of your vehicle...

    Other information:

    Jeep Wrangler 2018-2026 Owners Manual: Removing The Soft Top


    Use this QR code to access your digital experience. Fully lower the soft topCAUTION! Failure to follow the next steps could result in damage to the Soft Top or vehicle. Make sure the lift assist mechanism on both the left and right sides are in the “lock” position, and an audible “click” is heard when pushing down on the #1 bow from each of the lift assist mechanisms before removing...

    Jeep Wrangler 2018-2026 Owners Manual: ESC Activation/Malfunction Indicator Light And ESC OFF Indicator Light


    The ESC Activation/Malfunction Indicator Light in the instrument cluster will come on when the ignition is turned to the “ESC On” mode. It should go out with the engine running. If the ESC Activation/Malfunction Indicator Light comes on continuously with the engine running, a malfunction has been detected in the ESC system...

    Categories

    Erasing All The HomeLink® Channels

    To erase the channels, follow this procedure:

    Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

    NOTE:

    Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.

    read more

     
    Copyright © 2026 www.jewrangler.com