Jeep Wrangler: Blind Spot Monitoring (BSM) — If Equipped / Blind Spot Modes
Blind Spot has three selectable modes of
operation that are available in the Uconnect
system.
RCP is intended to aid the driver when backing
out of parking spaces where their vision of
oncoming vehicles may be blocked. Proceed
slowly and cautiously out of the parking space
until the rear end of the vehicle is exposed...
When operating in Blind Spot Alert mode, the
BSM system will provide a visual alert in the
appropriate side view mirror based on a
detected object. However, when the system is
operating in Rear Cross Path (RCP) mode, the
system will respond with both visual and
audible alerts when a detected object is
present...
Other information:
How long does it take to send the route and
destination to my vehicle? Depending on
various conditions, it can take up to three
minutes for the request to get through to
your vehicle.
Can I cancel a route I sent to my vehicle?
Yes, once you enter your vehicle, and start
the engine, the pop-up message stating that
you have a new route will appear...
The jack and lug wrench are located in the rear
cargo area. To remove jack and tools proceed
as follows:
Lift the load floor in the cargo area.
Load Floor
NOTE:
The load floor can be removed for easier access
by pulling the load floor directly rearward...