Jeep Wrangler: Child Restraints / Lap/Shoulder Belt Systems For Installing Child Restraints In This Vehicle
Automatic Locking Retractor Locations (Two-Door Models)
ALR — Switchable Automatic Locking Retractor
Top Tether Anchorage Symbol
Automatic Locking Retractor Locations (Four-Door Models)
ALR — Switchable Automatic Locking Retractor
Top Tether Anchorage Symbol
NOTE:
If the folding, non-adjustable head restraint interferes with the installation of the child restraint, the head restraint may be folded and the child seat installed in front of it (Two-Door Models).
WARNING!
Always make sure the head restraint is in its upright position when the seat is to be used by an occupant who is not in a child restraint. Sitting in a seat with the head restraint in its lowered position could result in serious injury or death in a collision.
Car Seat With Head Restraint Folded
- Folded Headrest
- Child Restraint
Installing Child Restraints Using The Vehicle Seat Belt
Child restraint systems are designed to be
secured in vehicle seats by lap belts or the lap
belt portion of a lap/shoulder belt.
WARNING!
Improper installation or failure to properly
secure a child restraint can lead to failure
of the restraint...
Installing A Child Restraint With A Switchable Automatic Locking Retractor
(ALR):
Child restraint systems are designed to be
secured in vehicle seats by lap belts or the lap
belt portion of a lap/shoulder belt.
WARNING!
Improper installation or failure to properly
secure a child restraint can lead to failure
of the restraint...
Other information:
Jeep Wrangler 2018-2024 Owners Manual: Wait To Start Light — If Equipped
This indicator light will illuminate for approximately two seconds when the ignition is turned to the ON/RUN position. Its duration may be longer based on colder operating conditions. Vehicle will not initiate start until telltale is no longer displayed...
Jeep Wrangler 2018-2024 Owners Manual: Rear Carpet (Two Door Models)
Remove the rear seats. Remove the sides grommets (one left and one right). First the grommet from the side carpet and then the rear carpet. Side Carpet Remove the grommets under the front seat (one left and one right). Then pull the carpet out to the rear and open the carpet split around the front seats brackets...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Manual Front Seat Recline Adjustment
- Automatic High Beam Headlamp Control — If Equipped, Flash-To-Pass
- Auxiliary Switches — If Equipped
- New on site
- Most important about car
Turn Signals. Lane Change Assist — If Equipped
Turn Signals
Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.
NOTE:
If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.
