Jeep Wrangler: WRANGLER TOPS / Provided Tools

For your convenience, a tool kit is provided with your vehicle located in the center console. This kit includes the necessary tools required for the operations described in the following sections. All pieces fit into the ratchet for easy use.

NOTE:

The soft top and the hard top are to be used independently. Your vehicle warranty will not cover damage resulting from both tops being installed at the same time.

Jeep Wrangler. Provided Tools

Provided Tools

  1. Ratchet
  2. #T50 Torx Head Driver
  3. #T40 Torx Head Driver
  4. 15 mm Socket

If your vehicle is equipped with a Dual Top (four door models only), the soft top system will be provided in a separate box located in the rear of the vehicle for shipping purposes only.

    WRANGLER TOPS

    ..

    Lowering The Soft Top Into Sunrider® Position

    Use this QR code to access your digital experience. WARNING! The fabric quarter windows and fabric top are designed only for protection against the elements...

    Other information:

    Jeep Wrangler 2018-2025 Owners Manual: Front/Rear Axle Fluid


    For normal service, periodic fluid level checks are not required. When the vehicle is serviced for other reasons the exterior surfaces of the axle assembly should be inspected. If gear oil leakage is suspected inspect the fluid level. Fluid Level Check Lubricant should be approximately 1/8 inch (3 mm) below the bottom edge of the oil fill hole...

    Jeep Wrangler 2018-2025 Owners Manual: To Start The Engine While In Autostop Mode


    When the gear selector is in NEUTRAL, the engine will start when the clutch pedal is pressed (does not require complete/full pedal press). The vehicle will go into STOP/START SYSTEM NOT READY mode until the vehicle speed is greater than 5 mph (8 km/h)...

    Categories

    Automatic Headlights — If Equipped, Lights-On Reminder

    Automatic Headlights

    This system automatically turns the headlights on or off according to ambient light levels. To turn the system on, rotate the headlight switch clockwise to the last detent for automatic headlight operation. When the system is on, the headlight time delay feature is also on. This means the headlights will stay on for up to 90 seconds after you place the ignition into the OFF position. To turn the automatic system off, move the headlight switch out of the AUTO position.

    read more

     
    Copyright © 2025 www.jewrangler.com