Jeep Wrangler: Electronic Stability Control (ESC) / Ready Alert Braking (RAB)

Rain Brake Support (RBS)

RBS may improve braking performance in wet conditions. It will periodically apply a small amount of brake pressure to remove any water buildup on the front brake rotors...

Selec-Speed Control (SSC) — If Equipped

SSC is intended for off-road driving in 4WD Low only. SSC maintains vehicle speed by actively controlling engine torque and brakes. SSC has three states: Off (feature is not enabled and will not activate) Enabled (feature is enabled and ready but activation conditions are not met, or driver is actively overriding with brake or throttle application) Active (feature is enabled and actively controlling vehicle speed) Enabling SSC SSC is enabled by pushing the SSC switch, but the following conditions must also be met to enable SSC: The driveline is in 4WD Low...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Electronic Throttle Control (ETC) Warning Light

This warning light will illuminate to indicate a problem with the ETC system. If a problem is detected while the vehicle is running, the light will either stay on or flash depending on the nature of the problem. Cycle the ignition when the vehicle is safely and completely stopped and the transmission is placed in the PARK (P) position...

Jeep Wrangler 2018-2026 Owners Manual: Jack Location

The jack and lug wrench are located in the rear cargo area. To remove jack and tools proceed as follows: Lift the load floor in the cargo area. Load Floor NOTE: The load floor can be removed for easier access by pulling the load floor directly rearward...