Jeep Wrangler: REMOTE START — IF EQUIPPED (GASOLINE) / Remote Start Front Defrost Activation and Comfort Systems — If Equipped
If applicable, refer to the “Hybrid Supplement”
for additional information.
To drive the vehicle after starting the Remote
Start system, either push and release the
unlock button on the key fob to unlock the
doors, or unlock the vehicle using Keyless
Enter-N-Go — Passive Entry via the door
handles, and disarm the Vehicle Security
system (if equipped)...
When Remote Start is active, and the outside
ambient temperature is 40°F (4.5°C) or below,
the system will automatically activate front
defrost for 15 minutes or less...
Other information:
If the door frames are installed from soft top
usage, they must be removed prior to
installation of the hard top. For removal
procedures.
To install the hard top, place the hard top on the
vehicle while making sure that the top is sitting
flush with the body at the sides and check to
ensure that there is a uniform gap between the
lift glass and hard top...
Remove the rear seats.
Remove the sides grommets (one left and
one right). First the grommet from the side
carpet and then the rear carpet.
Side Carpet
Remove the grommets under the front seat
(one left and one right).
Then pull the carpet out to the rear and
open the carpet split around the front seats
brackets...