Jeep Wrangler: OCCUPANT RESTRAINT SYSTEMS / Seat Belt Systems

Buckle up even though you are an excellent driver, even on short trips. Someone on the road may be a poor driver and could cause a collision that includes you. This can happen far away from home or on your own street.

Research has shown that seat belts save lives, and they can reduce the seriousness of injuries in a collision. Some of the worst injuries happen when people are thrown from the vehicle. Seat belts reduce the possibility of ejection and the risk of injury caused by striking the inside of the vehicle. Everyone in a motor vehicle should be belted at all times.

Important Safety Precautions

Please pay close attention to the information in this section. It tells you how to use your restraint system properly, to keep you and your passengers as safe as possible...

Enhanced Seat Belt Use Reminder System (BeltAlert)

Driver And Passenger BeltAlert — If Equipped BeltAlert is a feature intended to remind the driver and outboard front seat passenger (if equipped with outboard front passenger seat BeltAlert) to buckle their seat belts...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Things You Should Know About Uconnect Phone


Voice Command For the best performance: Always wait for the beep before speaking Speak normally, without pausing, just as you would speak to a person sitting a few feet/ meters away from you Ensure that no one other than you is speaking during a voice command period Low-To-Medium Blower Setting Low-To-Medium Vehicle Speed Low Road Noise Smooth Road Surface Fully Closed Windows Dry Weather Conditions WARNING! ALWAYS drive safely with your hands on the wheel...

Jeep Wrangler 2018-2026 Owners Manual: Fuel Filler Cap


The fuel filler cap is located on the driver's side of the vehicle. If the fuel filler cap is lost or damaged, be sure the replacement cap is the correct one for this vehicle. Fuel Filler Door Fuel Filler Cap WARNING! Never have any smoking materials lit in or near the vehicle when the fuel door is open or the tank is being filled...

Categories

Erasing All The HomeLink® Channels

To erase the channels, follow this procedure:

Place the ignition switch into the ON/RUN position. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes.

NOTE:

Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming additional buttons.

read more

 
Copyright © 2026 www.jewrangler.com