Jeep Wrangler: Forward Collision Warning (FCW) With Mitigation — If Equipped / Turning FCW On Or Off
The FCW button is located in the Uconnect
display in the control settings.
- To turn the FCW system on, press the forward
collision button once.
- To turn the FCW system off, press the forward
collision button once.
NOTE:
- When the FCW is “on”, this allows the system
to warn the driver of a possible collision with
the vehicle in front.
- When the FCW is “off”, this prevents the
system from warning the driver of a possible
collision with the vehicle in front. If the FCW
is set to “off”, “FCW OFF” will be displayed in
the instrument cluster display.
- When FCW status is set to “Only Warning”,
this prevents the system from providing
limited active braking, or additional brake
support if the driver is not braking adequately
in the event of a potential frontal collision.
- When FCW status is set to “Warning and
Braking”, this allows the system to warn the
driver of a possible collision with the vehicle
in front using audible/visual warnings and it
applies autonomous braking.
- The system will retain the last setting
selected by the driver after ignition shutdown.
The FCW with Mitigation system provides the
driver with audible warnings, visual warnings
(within the instrument cluster display), and may
apply a haptic warning in the form of a brake
jerk, to warn the driver when it detects a
potential frontal collision...
The FCW Sensitivity and Active Braking status
are programmable through the Uconnect
system.
Far
When the sensitivity of FCW is set to the
“Far” setting and the system status is
“Only Warning”, this allows the system to
warn the driver of a possible more distant
collision with the vehicle in front using
audible/visual warnings...
Other information:
Your vehicle may be equipped with a TrailCam
that allows you to see an on-screen image of the
front view of your vehicle. The image will be
displayed on the touchscreen along with a
caution note “Check Entire Surroundings”
across the top of the screen...
The ENGINE START/STOP button operates
similar to an ignition switch. It has three modes:
OFF, ACC, and RUN. To change the ignition
modes without starting the vehicle and use the
accessories, follow these steps:
Start with the ignition in the OFF mode...
Стоимость чистки бассейна комплект для чистки
aeclimate.com.