Jeep Wrangler 2018-2026 Owners Manual / MULTIMEDIA / UCONNECT MODES / Phone Mode / Audio Performance

Jeep Wrangler: Phone Mode / Audio Performance

Audio quality is maximized under:

Low-To-Medium Blower Setting
Low-To-Medium Vehicle Speed
Low Road Noise
Smooth Road Surface
Fully Closed Windows
Dry Weather Conditions
Operation From The Driver's Seat

Performance such as audio clarity, echo, and loudness to a large degree rely on the phone and network, and not the Uconnect Phone.

Echo at the far end can sometimes be reduced by lowering the in-vehicle audio volume.

Things You Should Know About Uconnect Phone

Voice Command For the best performance: Always wait for the beep before speaking Speak normally, without pausing, just as you would speak to a person sitting a few feet/ meters away from you Ensure that no one other than you is speaking during a voice command period Low-To-Medium Blower Setting Low-To-Medium Vehicle Speed Low Road Noise Smooth Road Surface Fully Closed Windows Dry Weather Conditions WARNING! ALWAYS drive safely with your hands on the wheel...

Phone Voice Commands

Making and answering hands-free phone calls is easy with Uconnect. When the Phonebook button is illuminated on your touchscreen, your system is ready...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Safe Usage Of The Uconnect System

The Uconnect system is a sophisticated electronic device. Do not let young children use the system. Permanent hearing loss may occur if you play your music or sound system at loud volumes. Exercise caution when setting the volume on the system...

Jeep Wrangler 2018-2026 Owners Manual: Normal Starting

Observe the instrument cluster lights when starting the engine. NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal. Always apply the parking brake. Press and hold the brake pedal while pushing the ENGINE START/STOP button once...

Turn Signals. Lane Change Assist — If Equipped

Turn Signals

Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation.

NOTE:

If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb.