Jeep Wrangler: Manual Adjustment Front Seats / Front Passenger Easy Entry Seat — Two Door Models
Pull upward on the easy entry lever located on
the outboard side of the seat back, and slide
the entire seat forward.

Easy Entry Lever
To return the seat to a sitting position, fold the
seatback upright until it locks and push the seat
rearward until the track locks.
NOTE:
- The front passenger seats have a track
memory, which returns the seat to its original
position.
- The recline strap and easy entry lever should
not be used during the automatic returning of
the seat to its sitting position.
The lumbar control knob is located on the
outboard side of the front driver seat. Rotate
the control forward to increase and rearward to
decrease the desired amount of lumbar
support...
To provide additional storage area, each rear
seat can be folded flat to allow for extended
cargo space.
NOTE:
Be sure that the front seats are fully upright
and positioned forward...
Other information:
Always use carpet designed to fit your vehicle.
Only use carpet that does not interfere with the
operation of the pedal assemblies. Only operate
the vehicle when the carpet is securely
attached by the grommets so it cannot slip out
of position and interfere with the pedal
assemblies or impair safe operation of your
vehicle in other ways...
While operating on gasoline with the required
octane number, hearing a light knocking sound
from the engine is not a cause for concern.
However, if the engine is heard making a heavy
knocking sound, see a dealer immediately. Use
of gasoline with an octane number lower than
recommended octane can cause engine failure
and may void the New Vehicle Limited Warranty...