Jeep Wrangler: SEATS / Manual Adjustment Front Seats
Seats are a part of the Occupant Restraint
system of the vehicle.
WARNING!
It is dangerous to ride in a cargo area,
inside or outside of a vehicle...
The seat can be adjusted forward or rearward
by using a bar located by the front of the seat
cushion, near the floor. While sitting in the seat,
lift up on the bar located under the seat cushion
and move the seat forward or rearward...
Other information:
The end caps on your vehicle’s front fascia/
bumper can be removed by following the steps
below:
NOTE:
Bumper end caps are removable on steel
fascia/bumper only.
Loosen the two bolts that retain the GAWR
bracket (Bolts #1 and #2) to the end cap
using a T45 torx bit screw driver...
The Occupant Restraint
Controller
(ORC) monitors the readiness of the
electronic parts of the air bag system
whenever the ignition switch is in the
START or ON/RUN position. If the ignition switch
is in the OFF position or in the ACC position, the
air bag system is not on and the air bags will not
inflate...