Jeep Wrangler: SEATS / Head Restraints
Head restraints are designed to reduce the risk of injury by restricting head movement in the event of a rear impact. Head restraints should be adjusted so that the top of the head restraint is located above the top of your ear.
WARNING!
- All occupants, including the driver, should not operate a vehicle or sit in a vehicle’s seat until the head restraints are placed in their proper positions in order to minimize the risk of neck injury in the event of a crash.
- Head restraints should never be adjusted while the vehicle is in motion. Driving a vehicle with the head restraints improperly adjusted or removed could cause serious injury or death in the event of a collision.
Rear Seat Armrest — If Equipped
The center part of the rear seat can also be
used as a rear armrest with cupholders. To
unfold it, grab the pull strap under the head
restraint and pull it forward...
Front Head Restraints
To raise the head restraint, pull upward on the
head restraint. To lower the head restraint,
push the adjustment button located on the
base of the head restraint, and push downward on the head restraint...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Jack Location
The jack and lug wrench are located in the rear cargo area. To remove jack and tools proceed as follows: Lift the load floor in the cargo area. Load Floor NOTE: The load floor can be removed for easier access by pulling the load floor directly rearward...
Jeep Wrangler 2018-2026 Owners Manual: Recreational Towing — Four-Wheel Drive Models
NOTE: The transfer case must be shifted into (N) Neutral, automatic transmission must be in PARK, and manual transmission must be in gear (NOT in NEUTRAL) for recreational towing. CAUTION! DO NOT dolly tow any 4WD vehicle. Towing with only one set of wheels on the ground (front or rear) will cause severe transmission and/or transfer case damage...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Automatic High Beam Headlamp Control — If Equipped, Flash-To-Pass
- Programming HomeLink® To A Garage Door Opener
- Engine Coolant Level — 2.0L
- New on site
- Most important about car
Automatic Headlights — If Equipped, Lights-On Reminder
Automatic Headlights
This system automatically turns the headlights on or off according to ambient light levels. To turn the system on, rotate the headlight switch clockwise to the last detent for automatic headlight operation. When the system is on, the headlight time delay feature is also on. This means the headlights will stay on for up to 90 seconds after you place the ignition into the OFF position. To turn the automatic system off, move the headlight switch out of the AUTO position.
Copyright © 2026 www.jewrangler.com