Jeep Wrangler: Apple CarPlay® / Messages
Push and hold the VR button on
the
steering wheel to activate a Siri voice
recognition session. Apple CarPlay®
allows you to use Siri to send or reply
to text messages. Siri can also read incoming
text messages, but drivers will not be able to
read messages, as everything is done via voice.
Music
Apple CarPlay® allows you to
access
all your artists, playlists, and music
from iTunes® or any third party
application installed on your device...
Maps
Push and hold the VR button on
the
steering wheel until the beep or tap
the Microphone icon to ask Apple®
Siri to take you to a desired
destination by voice...
Other information:
Jeep Wrangler 2018-2026 Owners Manual: Door Frame Removal
NOTE: In four door models, the rear door frames must be removed first, followed by the front door frames. Using the provided #40 Torx head driver and ratchet, loosen the Torx screws located on the underside of each door frame (two per door)...
Jeep Wrangler 2018-2026 Owners Manual: Identifying Whether You Have A Rolling Code Or Non-Rolling Code Device
Before programming a device to one of your HomeLink® buttons, you must determine whether the device has a rolling code or non-rolling code. Rolling Code Devices To determine if your device has a rolling code, a good indicator is its manufacturing date...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- WARNING LIGHTS AND MESSAGES
- Automatic High Beam Headlamp Control — If Equipped, Flash-To-Pass
- 2.0L Engine and 3.6L Engine
- New on site
- Most important about car
Basic Voice Commands
The basic Voice Commands below can be given at any point while using your Uconnect system. Push the VR button on the steering wheel. After the beep, say:
“Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. “Repeat” to listen to the system prompts again.
Copyright © 2026 www.jewrangler.com