Jeep Wrangler: Automatic Climate Control Descriptions And Functions / Mix Mode
Air is directed through the
floor,
defrost, and side window demister
outlets. This setting works best in cold
or snowy conditions that require extra
heat to the windshield. This setting is good for
maintaining comfort while reducing moisture on
the windshield.
Floor Mode
..
Other information:
Jeep Wrangler 2018-2026 Owners Manual: To Lock The Swing Gate
With a valid Passive Entry key fob within 5 ft (1.5 m) of the swing gate handle, pushing the Passive Entry lock button will lock the vehicle doors and the swing gate. NOTE: After pushing the door handle button, you must wait two seconds before you can lock or unlock the doors, using any Passive Entry door handle...
Jeep Wrangler 2018-2026 Owners Manual: LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps they are replaced as an assembly. Rear Tail, Stop, Turn Signal, And Backup Lamp See below steps to replace: Remove interior trim panel cap to access single retaining screw for tail lamp assembly. Trim Cap Remove retaining screw and disconnect electrical connector, then remove tail lamp assembly from the vehicle...
Categories
- Manuals Home
- Jeep Wrangler Owners Manual
- Jeep Wrangler Service Manual
- Turning FCW On Or Off
- SOS Call System Limitations
- WHEEL AND TIRE TORQUE SPECIFICATIONS
- New on site
- Most important about car
Bi-Level Mode
Air comes from the instrument
panel
outlets and floor outlets. A slight
amount of air is directed through the
defrost and side window demister
outlets.
NOTE:
Bi-Level mode is designed under comfort conditions to provide cooler air out of the panel outlets and warmer air from the floor outlets.
Copyright © 2026 www.jewrangler.com