Jeep Wrangler: MULTIMEDIA / CONNECTED VEHICLE SERVICES — IF EQUIPPED
It is possible to have multiple devices connected
to the Uconnect system. For example, if using
Android Auto™/Apple CarPlay®, the connected
device will be used to place hands-free phone
calls or send hands-free text messages...
Vehicles with an Assist and an SOS button are
connected vehicles. These buttons will be
located on either the rearview mirror or overhead
console, depending on the vehicle...
Other information:
During vehicle start up, when the ParkSense
Rear Park Assist System has detected a faulted
condition, the instrument cluster display will
actuate a single chime, once per ignition cycle,
and it will display the “PARKSENSE
UNAVAILABLE WIPE REAR SENSORS” or the
“PARKSENSE UNAVAILABLE SERVICE
REQUIRED” message...
Press and release this button on
the
touchscreen, or push the button on
the faceplate, to change the system
between recirculation mode and
outside air mode. The Recirculation indicator
and the A/C indicator illuminate when the
Recirculation button is pressed...
Categories
To erase the channels, follow this procedure:
Place the ignition switch into the ON/RUN
position.
Push and hold the two outside HomeLink®
buttons (I and III) for up to 20 seconds, or
until the HomeLink® indicator light flashes.
NOTE:
Erasing all channels should only be performed
when programming HomeLink® for the first
time. Do not erase channels when programming
additional buttons.
read more