Jeep Wrangler: UCONNECT INTRODUCTION / Safety And General Information

Drag & Drop Menu Bar

The Uconnect features and services in the main menu bar are easily customized for your preference. Simply follow these steps: Uconnect 4 With 7-inch Display Drag & Drop Press the Apps button to open the App screen...

Safety Guidelines

WARNING! ALWAYS drive safely with your hands on the steering wheel. You have full responsibility and assume all risks related to the use of the Uconnect features and applications in this vehicle...

Other information:

Jeep Wrangler 2018-2026 Owners Manual: Door Frame Installation Four Door Models — If Equipped


Install the front door rail first. Carefully place the front door rail in the rubber seal at the top of the windshield, and line up the holes for the Torx head screws (two for each door). Swing the frame bracket around the side of the rail, and insert the screws from underneath...

Jeep Wrangler 2018-2026 Owners Manual: LED Front Fog Lamp


If your vehicle is equipped with LED fog lamps they are replaced as an assembly. Rear Tail, Stop, Turn Signal, And Backup Lamp See below steps to replace: Remove interior trim panel cap to access single retaining screw for tail lamp assembly. Trim Cap Remove retaining screw and disconnect electrical connector, then remove tail lamp assembly from the vehicle...

Categories

Basic Voice Commands

The basic Voice Commands below can be given at any point while using your Uconnect system. Push the VR button on the steering wheel. After the beep, say:

“Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. “Repeat” to listen to the system prompts again.

read more

 
Copyright © 2026 www.jewrangler.com